1. Skip to Menu
  2. Skip to Content
  3. Skip to Footer>

Expert Sessions!

You are getting an error message SQL1092N (DB2)

23 January 2015

Written by Prakash Palani

Problem :  You are getting an error message SQL1092N (in DB2 environment)

ERROR: SQL ERROR -1092: SQL1092N  The requested command or operation failed because the user ID does not have the authority to perform the requested command or operation.  User ID: "SAP

Read Article

No Service for System SAP

11 June 2014

Written by Prakash Palani

You may end up with following error message while transferring IDOC based messages to PI.

Below are the sequence of steps recommended to troubleshoot the same.

1. Business System Maintenance in SLD

2. Logical System Assignment to Business System

3. Clear SLD Cache in Integration Builder

4. In Integration Builder, make sure appropriate logical system is visible under "Adapter Specific Identifier" in Business System Configuration. If the logical system is not reflecting, then click on "Compare with System Landscape Directory" (tiny button under Adapter Specific Identifier).

5. Perform SXI_CACHE - Full Cache Refresh

6. Create port entries in transaction IDX1

7. Make sure the metadata is loaded in transaction IDX2

 

No Service for System SAP

WebUI Not Starting

26 May 2014

Written by Prakash Palani

CRM WebUI is not starting / opening up.

Since the hardware in which the SAP instance was running was having very limited hardware resources, ABAP engine was not able to cater to end user requirements on time, as a result, CRM WebUI couldn't be started up.

Solution :

* Increase the ICM timeout parameters

* Increase the global area MB parameter

* Increase the Memory/CPU whichever is having bottleneck.

 

Thanks

PrakashP

WebUI Not Starting

WebUI Not Starting

26 May 2014

Written by Prakash Palani

CRM WebUI is not starting / opening up.

Since the hardware in which the SAP instance was running was having very limited hardware resources, ABAP engine was not able to cater to end user requirements on time, as a result, CRM WebUI couldn't be started up.

Solution :

* Increase the ICM timeout parameters

* Increase the global area MB parameter

* Increase the Memory/CPU whichever is having bottleneck.

 

Thanks

PrakashP

WebUI Not Starting

No RFC Destination for SID

15 May 2014

Written by Prakash Palani

This is a simple tip, you might end up with the following error message during the extractor setup as part of "Managed System Configuration", take a look at the steps to resolve section.

No RFC Destination for SID

RFC Destination Cannot be Retrieved for System

 

 

 

Steps to Resolve

* Make sure that the RFC Destination is configured for at least one client

* Make sure SMD_RFC user has necessary authorization to make use of the RFC Destinations.

Thanks

PrakashP

No RFC Destination for SID

FollowUs on Twitter

SAP Web Dispatcher

SAP Web Dispatcher

Defining Backup Strategy

Defining Backup Strategy

Security Patch Strategy

Defining Security Patch Strategy

RCA Setup Guide

RCA Setup Guide for BI SBOP (BOBJ)

End-To-End SSL Setup

End-To-End SSL Setup Guide for Web Dispatcher